[3absiso]

Originally Posted by zeruel85 Hi everyone! I sent an email for checking my nand dumps. I followed baileyscream tutorial and the official Validating flash dumps wiki page of PS3DevWiki. Thank you for your work.

YOUR DUMP IS VALID

PS3 Model: CECHExx

Mobo: COK-002

NOTE:
- The IDPS is 3 and Not 4 as in the WikiDev
- The 00s are 1.31% < 1.43% as in the WikiDev

The percentage for the new FW are less than the WikiDev Percentage, but once you patch it, check the 00s it will be in range.

regarding the PS3 ID, we checked one before with the same ID deference and downgraded successfully.

[zeruel85]

Originally Posted by 3absiso YOUR DUMP IS VALID PS3 Model: CECHExx Mobo: COK-002 NOTE: - The IDPS is 3 and Not 4 as in the WikiDev - The 00s are 1.31% < 1.43% as in the WikiDev The percentage for the new FW are less than the WikiDev Percentage, but once you patch it, check the 00s it will be in range. regarding the PS3 ID, we checked one before with the same ID deference and downgraded successfully.

Thanks a lot!

In fact my PS3 is a CECHCxx (COK-002), so the IDPS/Target_ID is correct, but I had some doubts about metldr and bootldr, because they don't correspond to a CECHCxx if you look at the official PS3DevWiki table. But I found a Talk in PS3DevWiki in which there is a table where bootldr 2A 3F (mine) corresponds also to CECHCxx, so I think it's all right.

P.S.: statistics after patching look good!

Inviato dal mio GT-I8150 con Tapatalk 2

[3absiso]

Originally Posted by zeruel85 Thanks a lot! In fact my PS3 is a CECHCxx (COK-002), so the IDPS/Target_ID is correct, but I had some doubts about metldr and bootldr, because they don't correspond to a CECHCxx if you look at the official PS3DevWiki table. But I found a Talk in PS3DevWiki in which there is a table where bootldr 2A 3F (mine) corresponds also to CECHCxx, so I think it's all right. P.S.: statistics after patching look good! Inviato dal mio GT-I8150 con Tapatalk 2

is it refurbished ???

[zeruel85]

Originally Posted by 3absiso is it refurbished ???

Sorry, it isn't mine, so I can't answer to your question.

Is there a way to know that?

Inviato dal mio GT-I8150 con Tapatalk 2

[daveyaz]

Hi...

I tried Downgrade by E3 flasher after you validated my dump...but in the process the lights were flashing...i hit the stop...then tried again...my ps3 is now powering on and after 2-3 sec it powers off.....!!!!!

i can upload my log file if you like to test it and help me...

[MJ999]

Originally Posted by daveyaz Hi... I tried Downgrade by E3 flasher after you validated my dump...but in the process the lights were flashing...i hit the stop...then tried again...my ps3 is now powering on and after 2-3 sec it powers off.....!!!!! i can upload my log file if you like to test it and help me...

This ain't a HELP thread.

You have to connect a wire from Trisate to GND in order for you to flash your ps3.

[MoREL]

just sent my dumps

[haz367]

Originally Posted by zeruel85 Sorry, it isn't mine, so I can't answer to your question. Is there a way to know that? Inviato dal mio GT-I8150 con Tapatalk 2

yup, there must a be a refurbished white sticker on the bottom of the PS3

[3absiso]

Originally Posted by haz367 yup, there must a be a refurbished white sticker on the bottom of the PS3

I also saw small yellow Circle sticker on the Mobo for one of the refurbished PS3 i worked on

[daveyaz]

Originally Posted by MJ999 This ain't a HELP thread. You have to connect a wire from Trisate to GND in order for you to flash your ps3.

Sorry for asking help....
I just couldn't know what to do ....

Thanks for your help.....

So iwill connect a wire as shown and then continue with regular downgrade ...