[nick64]

Hello again guys.
After finishing this tutorial http://www.ps3hax.net/showthread.php?t=50088 my PS3 it seems to have (yes again) another problem.
Here is my problem:

[mrc1978]

I assume you did try to reboot the system?

[nick64]

What do you mean?
I reached to this step "21. Wait for about 30 seconds for the PS3 to shut off by itself.", my ps3 turned off and when I turned it on it was the screen with the connect the controler. I did it and that is what it showed to me...

[3absiso]

Originally Posted by nick64 What do you mean? I reached to this step "21. Wait for about 30 seconds for the PS3 to shut off by itself.", my ps3 turned off and when I turned it on it was the screen with the connect the controler. I did it and that is what it showed to me...

i guess you went into FSM and get out without setup Rogero V3.7.

[nick64]

I set up this one Rogero 4.30 v2.05

[3absiso]

Originally Posted by nick64 I set up this one Rogero 4.30 v2.05

This can be used also.
did you check the log. did it say Success at the end

[nick64]

"updating SUCCESS(0x8002f000)
set product mode (ret = 0)
Total Elapsed time = 152977 msec"

It said that it was successful...
************* [ - Post Merged - ] *************
Also I just tried again this steps:

"Turn PS3 on and you should see the connect controller screen.
Then cut the power by pulling the plug or by the power switch.
Insert downgrade dongle into the right most USB port.
Plug PS3 back in, and press power then eject.
Wait for the dongle to communicate with the PS3 and the PS3 will shut off automatically.
Put either Rogero v3.7 or Rogero 4.30 v2.05 (RENAME TO PS3UPDAT.PUP) and this Lv2diag.self on the root of a FAT32 formatted USB stick.
Replace the downgrade dongle with the USB stick, in the right most USB port.
Wait for about 4 or 5 minutes for the firmware to install, and the PS3 to shut off by itself.
Now put this Lv2diag.self by itself on a FAT32 formatted USB stick.
Put the USB stick in the right most USB port and press power on the PS3.
Wait for about 30 seconds for the PS3 to shut off by itself."

and now nothing happens...

[3absiso]

What nothing means here

[nick64]

nothing means:

1. Wait for the dongle to communicate with the PS3 and the PS3 will shut off automatically. (Didn't happend the second time)
2. Wait for about 4 or 5 minutes for the firmware to install, and the PS3 to shut off by itself. (same)
3. Now put this Lv2diag.self by itself on a FAT32 formatted USB stick and Wait for about 30 seconds for the PS3 to shut off by itself (same and here)...

The first time everything happened like the description in guide. But now nothing happens.

[playerkp420]

After you do step 21. When you turn your PS3 on, it will tell you to connect the controller. Then you have to setup your language, time zone, date and time, and network settings.