[nick64]

Originally Posted by playerkp420 After you do step 21. When you turn your PS3 on, it will tell you to connect the controller. Then you have to setup your language, time zone, date and time, and network settings.

Yes I know that but the problem is that nothing like this showed up in my screen...

[playerkp420]

Originally Posted by nick64 Yes I know that but the problem is that nothing like this showed up in my screen...

You said it showed to connect the controller? Did you connect the controller?

[haz367]

why did u use that guide if i may ask? ur only problem was the PSP making nto a FSM dongle wich donkey-punch explained u and worked....u had a "bad backup" or what?...just asking

[nick64]

Yes I did. And after this, it gave me this message:



There is a small chanse to mixed up by mistake the two Lv2diag.self. But I don't think so. I really don't remember.
************* [ - Post Merged - ] *************

Originally Posted by haz367 why did u use that guide if i may ask? ur only problem was the PSP making nto a FSM dongle wich donkey-punch explained u and worked....u had a "bad backup" or what?...just asking

That was my problem http://www.ps3hax.net/showthread.php?t=50498. That's why I followed this guide.

[playerkp420]

Originally Posted by nick64 Yes I did. And after this, it gave me this message: There is a small chanse to mixed up by mistake the two Lv2diag.self. But I don't think so. I really don't remember. ************* [ - Post Merged - ] ************* That was my problem http://www.ps3hax.net/showthread.php?t=50498. That's why I followed this guide.

I don't think you made it all the way to step 21. Not correctly, anyway.

What does your PS3 do now?

[haz367]

ah..ok...what a mess tho..hope u get it up&running...goodluck

[nick64]

Now it says:

Connect the controler with a usb cable and press the PS button.

I did it and it showed the same message again.
The only thing that maybe I haven't done correctly was to changed by mistake the two Lv2diag.self (303 kbs and 202 kbs).

[playerkp420]

Originally Posted by nick64 Now it says: Connect the controler with a usb cable and press the PS button. I did it and it showed the same message again. The only thing that maybe I haven't done correctly was to changed by mistake the two Lv2diag.self (303 kbs and 202 kbs).

So, your flasher is connected good. Otherwise you would not get that screen after flashing your patched dump.
You need to enter FSM again, with your jig. Then install the firmware again.
Remember to pull the power plug from the PS3, before trying the power, eject trick.

If you can't enter FSM, follow the guide below, starting with Chapter 2, Part 1, METHOD 1.

[nick64]

So i have to put back again the e3 flasher or not?

[playerkp420]

Originally Posted by nick64 So i have to put back again the e3 flasher or not?

You don't have the flasher installed?

Use FSM then.