[3absiso]

Originally Posted by ellaham flashed orjinal dump turn off 5-10 sec later. flashed patched dump.. black screen,no usb power but have hdd activity

Ok
Let us try this, we wanna make sure the clip is seated correctly. flash your original dump then back it up and compare the two dumps.
if they match then the clip is seated if not it means you have to seat it again.
repeat the process till you have a matching dumps.
then flash back your original dump again and see what happens.

[saqibmush]

At last I got an trick to seat da clip properlyy...

Console was bricked

Now whenever I flash fun my original dump it came back to kife but console is in factory service mode wid OFW 4.31

N if I flash fun the patched dump in flash fun I hav hdd activity n no display but console switches of automatically in 10 seconds suggestions guyz
************* [ - Post Merged - ] *************


What I have done
Put an screw guage ti permanently push clip downward
Wiith one coin at the top n one at the down
************* [ - Post Merged - ] *************
Let me knew if that link doesnt work for u guys

[saqibmush]

tried this method also..
Place the e3_downgrade.bin and the bkpps3.bin you made on a micro SD Card.
2. Flip all switches down, except the last one (Lock/Unlock). Turn the PS3 on. While in the XMB press START on the flasher and the programming process will begin. The LED's on the indicator will progressively reach 100% (Once finished they will flash alternatively).

MY CONSOLE SWITCHES off automatically..



************* [ - Post Merged - ] *************
lip all switches down. Turn the PS3 on. While in the XMB press START on the flasher and the programming process will begin. The LED's on the indicator will progressively reach 100% (Once finished they will flash alternatively).

tried this one also but same condition..

but one in both the case if ill connect ground and tristae than it remains on but gives no display..
************* [ - Post Merged - ] *************
tried this also
Flip all switches down, except the first one (Flash Fun). Turn the PS3 on (If you get a 1101111 error the Tristate is not on correctly). When PS3 is powered on, press the START button on the E3 and wait for the LED's on the indicator to reach 100%
************* [ - Post Merged - ] *************
and if restore it with originale dumo in flash fun
it came back to life but in Factory Service Mode
************* [ - Post Merged - ] *************
i was using flash drive wid NTFS formatt..
Now i used it with FAT32 n suucesfully downgraded my console...
Special thanx to Playerkp42o...
Regards
Saqib Mushtaq
Islamabad, Pakistam
************* [ - Post Merged - ] *************
n thanx ps3 hax network