[jamesst20]

Yeah I see but isn't there a way to keep the console on or well leave electricity on the nor chip even if the console has a Ylod? There must be a way, please

[jamesst20]

Still waiting if anyone have something to share

Envoyé depuis mon Nexus 7 avec Tapatalk

[mewoahits]

If the hair dryer doesn't work. Since you're tossing those ylod consoles eventually anyway. Take the boards and heat your kitchen over to 275 degrees, Take out a baker pan and roll up tin foil balls and put the board on top of that. Throw it in the oven for like 7 minutes. Replace thermal paste and you should be able to get those to come on for atleast long enough to get the ID off it. If you weren't junking those I would reflow them. Old video card trick I learned back with an 8800GT.

[Mr.Dutch]

if there was more info from those boards, it would be possible to bypass the power problem.

[DebugBrain]

Originally Posted by jamesst20 Bump pelase edit : Succeed to get Console ID! Now I only need to be able to make dumps on those

Teensy2 + + using the method Crackmyday can dump the NOR also on ps3 with YLOD, is what I did today on a DYN-001 with ylod

[jamesst20]

Originally Posted by DebugBrain Teensy2 + + using the method Crackmyday can dump the NOR also on ps3 with YLOD, is what I did today on a DYN-001 with ylod

Require 52 solders does it?

[DebugBrain]

Honestly I never understood why the teensy has not been appreciated as the others flashers, probably due to the fact that others have the NOR clip, even though many have had problems using them.
Applying the method of Crackmayday with teensy2 + +, you must at some point unplug the power cable of the ps3, this means that the NOR continues to be fed anyway.
The teensy not have the convenience of a NOR clip but in its favor it must be said this costs very little
For the Crackmyday method are required only 47 welds, some points of teensy should not be welded, using this method I was able to dump NOR on ps3 with YLOD, RLOD and also on briked ps3 ,
you just have to be careful in making a correct installation but I assure you that it works wonderfully


PS: Sorry if I do not speak English well : Redface:

[Madvil]

You can find your consoleID from that PS3 NOR/NAND dump, using HxD. I don't remembre the good offset but yea just search for "00000001" :-)

[jamesst20]

Yep I know that but I can't dump it :/

Envoyé depuis mon Nexus 7 avec Tapatalk

[4DoorITR]

Originally Posted by jamesst20 Yeah I see but isn't there a way to keep the console on or well leave electricity on the nor chip even if the console has a Ylod? There must be a way, please

Can't you just feed 3.3v to the NOR VCC pin?