[baileyscream]

Originally Posted by Mr.Dutch the right pin is the pwm (speed control) , left pin is 12V the third it looks grounded, but ofcourse it should not be.

yes that's what I was saying. ;P

[3absiso]

Originally Posted by MoREL

Wow
There are 3 Pins to the other side of the Mobo, try solder the fan wires to them. but make sure you connect them in order. it should work

[MJ999]

Originally Posted by Mr.Dutch the right pin is the pwm (speed control) , left pin is 12V the third it looks grounded, but ofcourse it should not be.

What if we cut the PWM ( Speed control ) wire ?

[Mr.Dutch]

Originally Posted by MJ999 What if we cut the PWM ( Speed control ) wire ?

it's like cutting off your legs
you still have the energy (like the 12V going to the fan), but you can't walk.

yeah i know, you probably won't get what i mean.

EDIT:

Originally Posted by MoREL hi, i've ps3 cech-2501b when i installed e3 nor clip the ps3 wont start

ooh please, get me a high res picture from the power/eject board connector (on mainboard, both sides of the board, i need to identify some traces going there.

[DebugBrain]

it also seems that the 12v is shorted to gnd, confirm?
I checked a dyn 001, the right pin is not connected on gnd

[Mr.Dutch]

Originally Posted by DebugBrain it also seems that the 12v is shorted to gnd, confirm?

he would have a burn hole in his mainboard if this was the issue.

[DebugBrain]

Yeah, you're right, but in the picture looks a short, seemed strange to me, that's why I asked