[smarcix]

Hi! I have a progskeet 1.2, if I use it soldering my dyn 001 (then nor), I can read and write, or only read?
Thanks for all,
sorry my bad english
Smarcix

[MJ999]

You can only read the nor at the moment.

[smarcix]

thanks, then I have to use my progskeet 1.1... thanks for all!!

[3absiso]

Originally Posted by smarcix thanks, then I have to use my progskeet 1.1... thanks for all!!

Why you are asking if you have the ProgSkeet V1.1
it is the best you can find, i hope i can find another one of it,
i received v1.2 while ago and put it on the shelf

[Sarah1331]

Rather than search he just wanted to know if it was fixed yet is my guess

[underwurlde]

Originally Posted by 3absiso Why you are asking if you have the ProgSkeet V1.1 it is the best you can find, i hope i can find another one of it ...

IF I can source some Actel ProASIC3 A3P125 FPGA's, then it will be born again. PCB is ready & all other bits & bobs that go to make it.

A

[3absiso]

Originally Posted by underwurlde IF I can source some Actel ProASIC3 A3P125 FPGA's, then it will be born again. PCB is ready & all other bits & bobs that go to make it. A

this one i am buying no kidding.
and sorry for the last time

[jhax78]

Originally Posted by underwurlde IF I can source some Actel ProASIC3 A3P125 FPGA's, then it will be born again. PCB is ready & all other bits & bobs that go to make it. A

aren't the actels programmed in factory?
at least that's what i have been reading after that you can update with the bit-stream

otherwise it would be ridiculous easy to clone te mofo
which is not the case because of the AES encryption it uses

i wondered it myself asked @euss NL to verify but so far it can't be done

[Sarah1331]

Originally Posted by underwurlde IF I can source some Actel ProASIC3 A3P125 FPGA's, then it will be born again. PCB is ready & all other bits & bobs that go to make it. A

Have you thought of trying a 250 as the skeet 1.2 was made for this


Sent from my iPhone 5 using Tapatalk 2

[underwurlde]

Originally Posted by jhax78 aren't the actels programmed in factory? at least that's what i have been reading after that you can update with the bit-stream otherwise it would be ridiculous easy to clone te mofo which is not the case because of the AES encryption it uses i wondered it myself asked @euss NL to verify but so far it can't be done

Really?!?

Don't know this as I have no truly blank devices. Then again, isn't the ProgSkeet v1.2 shipped unprogrammed and hence 'blank'??

@Sarah1331 , I cannot seem to source any Actel FPGA devices...

Andy