[haz367]

deleting mman or incomplete cant make the ps3 not boot anymore..right..then it would
be the first time, mman wil only report the build is not supporting the firmware(04.18.00)
then update from mman/online or offline to 04.19.00, base or full, only installing an "UPD" would result in a incomplete/corrupt mman install

the only things i can come up with..even tho its going down after 3sec? with beeps?

pull/switch the power completly at the back of PS3
put back power cable/switch ON
quikly press after eachother on frontbuttons "power+eject" and see what the PS3 does, if lucky it does its magic and goes into FSM (the PS3 shutsdown by itself after awhile) so dont do nothing til its OFF (gives no beep), reboot into FSM.....if it boots ofcourse...this is atleast the way to "trigger" FSM on this 4.31CFW exitout with 202kb lv2diag.self

[Bazigar]

Yes the ps3 is going down after 3 sec with 2-3 beeps.

i tried with pull/switch the power completly and put back power cable/switch ON then "power+eject" . may 20-30 times.
ps3 only shutdown after 3 sec even with this method.

I did a multiman online update but with same "incomplete" msg from multiman. before i uninstalled it .

[haz367]

must be a softbrick? to bad u did not make a backup with mman or rebug toolbox of the NOR/NAND, if u can't get it booting a flasher like E3 for NOR consoles is possible to make it run again.. sucks man..this cfw for my experience was good and stable

ps: dont quote me on it..but a bad firmware install/softbrick, yes it may be the glue but this wont RLOD(green led>red led) this type of brick is like YLOD(green led-yl led-red led) can u verify? the power led on frontpanel..or maybe overheat

[playerkp420]

Originally Posted by Bazigar Yes the ps3 is going down after 3 sec with 2-3 beeps. i tried with pull/switch the power completly and put back power cable/switch ON then "power+eject" . may 20-30 times. ps3 only shutdown after 3 sec even with this method. I did a multiman online update but with same "incomplete" msg from multiman. before i uninstalled it .

What is your model #?

I don't think a bad install of mm, can cause a brick. At most you might get corrupted data message.
More than likely overheated YLOD.
You can confirm this if you have a nor model. And ground the tristrate.

[haz367]

dont think..it simply cant be mman..

[Mr.Dutch]

Originally Posted by haz367 dont think..it simply cant be mman..

multiman is evil, i should make another comic about him.

[mrc1978]

Originally Posted by Mr.Dutch multiman is evil, i should make another comic about him.

Yes I think you should. Should be a weekly comic strip

[Mr.Dutch]

Originally Posted by mrc1978 Yes I think you should. Should be a weekly comic strip

if i only had the inspiration and some drawing skills.

btw, i hate multiman too much too make a comic about it.

[mrc1978]

Originally Posted by Mr.Dutch if i only had the inspiration and some drawing skills. btw, i hate multiman too much too make a comic about it.

Yeah but you could incorporate iris....sounds like a bird, and have fun

[raddog]

Two problems here this cfw has a controller sync problem and the corev7 update dont have all the files in them....can the op plz check the upload plz...thanks.