[hugolein]

Hi, I joined the board with Nand ProgSkeet 1.2 and GND, soldered 3.3 volts.
News Bitstream intstalliert 121106_2121 on ProgSkeet.

Nand chip is not recognized Unknow

Please solution

see picture
ttp://s1.directupload.net/file/d/3159/qy4hrysq_jpg.htm

[Sarah1331]

Clip not connecting correct buddy have you used a clamp??

You can always remove tsop and put on adaptor board then you don't need clip

[hugolein]

Clip not connecting correct buddy????

[Sarah1331]

Clip not touching the NAND legs properly

[Sarah1331]

i have been alearted to an error with progskeet 1.2 and this adaptor i am looking into it anyone who purchased for use on a 1.2 pm me for a refund if it doesnt work

am trying to get hold of a 1.2 to test

[hugolein]

Hello, the board does not work with the ProgSkeet 1.2, here is my Paypal xxxxxxx for reimbursement.
Board not operating.

[Sarah1331]

Originally Posted by hugolein Hello, the board does not work with the ProgSkeet 1.2, here is my Paypal for reimbursement. Board not operating.

Pm replied to and I'd remove your email bud

[FYC999]

@Sarah1331 thanks for taking the time and putting in the work for this device.

[hugolein]

Could you send me a picture where I need to solder the wire!

[Sarah1331]

Found error and hoping to get replacements soon so hopefully you can have replacement or you can just send it back for refund