[microlity]

When I downgraded my CECHL via Flash Fun Mode (E3-Flasher), there was newly Rogero V3.0 available and I wanted to directly Downgrade to this Version.

Like many People I had the BSOD-Problem. So I decided to use Rogero V2 instead which made no problems while Downgrading. After I checked the functionality (all ok), i tried to update to Rogero V3 via Recovery Mode. At this time, no BSOD-Problem. All ok from now on.

Recently, i managed to solder A/CE-Point to SBCE to initialize Dual Boot. Now i have successfully copied PS3-NOR to E3-NOR. On both NOR's are currently the same basic Firmware (Rogero V3.0).

Before I finally begin setting up Dual Boot: Shall I upgrade to Rogero V3.1 via Recovery Mode like I did from V2 to V3.0?

And: Was it ok to Update from Rogero V2 to V3. I mean, will Dual Boot still work for me?

Hope you can help me...

[microlity]

Is there really nobody who can answer if updates on CFW are allowed when Dual Boot isn't fully setted up, yet?

[Ron36]

maybe if you asked in the correct section!

This is not the help section!

[microlity]

Sure, but it's Downgrade related Question..

[microlity]

Ok, i will test it this weekend.. Will report if i had success!

Is it right that i can restore PS3 on every point in case of a brick. Valid NOR-Backup exists..

[playerkp420]

Originally Posted by microlity Ok, i will test it this weekend.. Will report if i had success! Is it right that i can restore PS3 on every point in case of a brick. Valid NOR-Backup exists..

Make a new backup before and after you install a different firmware. Will be easier to recover if you brick, if u have the backup of the firmware you were on when u bricked.

But you should be fine updating rogero v3.0 to v3.1. Just install via recovery menu.