[D1st0rt3dM1nd]

Hello,
I'm look for one last answer. I have been searching all over.

I now know the location of the "A" and "B" location on a DIA-001 is removing the resistor next to the NOR chip and soldering on the left side. Then soldering the other end to the SBCE on the E3 ribbon....correct?

Now what I cannot find is where do I find the tristate and once found where do I solder the other end to?

Please any help would be wonderful

Thank you

[Bigbones87]

yuo solder one end to nor tristate and the other end to the sbe on the clip ribbon. you can find the nor tristate for your board on ps3devwiki

[D1st0rt3dM1nd]

Originally Posted by Bigbones87 yuo solder one end to nor tristate and the other end to the sbe on the clip ribbon. you can find the nor tristate for your board on ps3devwiki

SO where it says TRI in this picture I would assume that is the NOR tristate location. So I solder there and the other end goes to the SBE on the E3 ribbon?
http://www.ps3devwiki.com/wiki/File:DIA-001_NOR.JPG

[Bigbones87]

yup. be careful tho because you can heat the tristate up too much and make it lift from the motherboard and then you will a big issue on your hand.
************* [ - Post Merged - ] *************
you only need to solder the tristate to sbe for unbricking. you can go ahead and do it while you are in there soldering to make things easy, but it isnt required for dual boot

[D1st0rt3dM1nd]

Thank you very much Bigbones, mush appreciated

Going to do the tristate now while I got this thing tore apart.