[daveyaz]

Originally Posted by haz367 the first switch doesn't matter, with Tristate to any GND it will halt forever if u not remove the wire after dumping/flashing(if valid) so the important e3 switch = switch 3 = UP

So if i got you right. here what i should do :

1.Connect a wire between TRI & GND on the board.

2. all switched down. only 3 Up.

3. Press power on.

4. and.....

[haz367]

dump..verify..dump..verify..good? all swiches down with patched dump..restore...remove gnd wire and croos fingers it alive?

[daveyaz]

Originally Posted by haz367 dump..verify..dump..verify..good? all swiches down with patched dump..restore...remove gnd wire and croos fingers it alive?

ok...i'll try and see....

what is patched dump ?

[haz367]

please do some research onboard..please..thx
it really is all there...but kay...patched = patched original dump(bkpps3.bin+355/430 coreos files) ready for downgrade...goodluck

[daveyaz]

ok thanks
i will read more

[daveyaz]

Originally Posted by 3absiso Hay; As we Said before 1- Wire between TRI on mobo to SBE on the Clip. 2- turn on your PS3, it will halt (It will not turn off) 3- put your flasher in (Fun Flash 100000) ( All switches Down but the First Up). 4- put your original Dump on the SD Card and put it in the Flsher 5- press the Reset Button (Red Button under the Esata Cable) 6- Press Start, and wait till the all blue leds finish.

OK...what will be next if this works....

how will continue downgrading ??

please be as much specific you can...

do i have to update the e3 flasher ?

what files to use///


thanks//////

[end55]

thanx for this informatiom

[daveyaz]

Originally Posted by haz367 please do some research onboard..please..thx it really is all there...but kay...patched = patched original dump(bkpps3.bin+355/430 coreos files) ready for downgrade...goodluck

Do u have these files I can download. ..
I wired my ps3 and its on now...what is next..what files how to restore....
Thank

[daveyaz]

ok....my ps3 is now powering on normaly without powering off again....

now how can i go on ????


any one ??????

thankssssssss

[3absiso]

Originally Posted by daveyaz ok....my ps3 is now powering on normaly without powering off again.... now how can i go on ???? any one ?????? thankssssssss

Did you flash your original Dump with Fun flash? if no do it then
1-Remove the wire you soldered
2- Yo either do one Key Flash (000001) all down except the last one up, putting your original Dump with + E3-downgarde.bin or you put a patched dump using rogero V0.01 with all switches down and flash it.