[noobzega]

Hello guys, I have good valid dump.

I try downgrade with downgrade.bin but get this error..


1 0 0 0 1 1 0 0 Failed to initialize PS3 BIOS Check pads / clip at PS3 board check may not be properly seated


If i power off ps3 he's bricked or? :S
************* [ - Post Merged - ] *************
Also get this errorr..

1 0 0 0 1 1 1 1 Failed to write PS3 BIOS Check pads / clip at PS3 board check may not be properly seated
************* [ - Post Merged - ] *************
E3 flasher log says.

start logging...
One Key downgrade mode.
fail to initialize PS3 BIOS.
************* [ - Post Merged - ] *************
@3absiso , @playerkp420 , @baileyscream

[playerkp420]

Answered you in your PM.

Reseat clip and do this: http://www.ps3devwiki.com/wiki/E3#Fl...for_Debricking

[Acoustikid11]

Tape 3 pennies on top of the clip and then reassemble it. I had the same problem my first time

[noobzega]

Nah, now PS3 is bricked, need to open it and first take photo of Mother board, then need to solder... nah..
************* [ - Post Merged - ] *************
Motherbooard is

DYN-001

I uload picture for 5-10 minutes, so please some mark me where i need to solder SBE.

[3absiso]

Originally Posted by noobzega Nah, now PS3 is bricked, need to open it and first take photo of Mother board, then need to solder... nah..

Your Dump is OK;
you need t solder a wire from SBE on the ribbon to TRI State to halt your PS3, but your ps3 in Fun Flash (100000) to halt

[noobzega]

Originally Posted by 3absiso Your Dump is OK; you need t solder a wire from SBE on the ribbon to TRI State to halt your PS3, but your ps3 in Fun Flash (100000) to halt

Sure mate, need to upload picture so someone need to mark wher to solder it.
************* [ - Post Merged - ] *************
So first I need to solder TRI State to modbo, then I need to flash fun 100000 valid dump just once or?

[playerkp420]

Originally Posted by noobzega Sure mate, need to upload picture so someone need to mark wher to solder it. ************* [ - Post Merged - ] ************* So first I need to solder TRI State to modbo, then I need to flash fun 100000 valid dump just once or?

Find your mobo here. http://www.ps3devwiki.com/wiki/Hardware_flashing#NOR

[noobzega]

DUUUUMP _P

[3absiso]

Originally Posted by noobzega Sure mate, need to upload picture so someone need to mark wher to solder it. ************* [ - Post Merged - ] ************* So first I need to solder TRI State to modbo, then I need to flash fun 100000 valid dump just once or?

This is your Mobo:



the point is to the laft: GP2 (Nor_TRISTATE)

[playerkp420]

Follow the guide I linked it the first post, and PMed you.

To know for sure your clip is on good, flash your dump, then make a backup, and compare the 2 with HxD analysis tab, file compare.