[-={Nexus}=-]

Flashed on original dump, on a sur-001 ps3 slim motherboard and received a black screen. It runs but there is no sound or video. Tried video reset and it still brought up nothing on screen as well as tried a new hdmi cable and av cords for video. Even tried to downgrade with it in this state both with downgrade.bin one-key downgrade and flow rebuilder patch and it would simply ylod once process was finished. The log file after downgrade read that it went through OK. Flashed back on original dump again and back to the black screen the same as before.

Any suggestions would be greatly appreciated and thank you for your time.
************* [ - Post Merged - ] *************
After reading someone elses thread, i followed playerpk420's suggestion and made a backup of the ps3 after flashing on the original dump file. I compared my original dump with what was flashed on and they both are identical. SO this would rule out any bad connections during the flash procedure. Why am I getting a black screen? So frustrated ...ARGh!

[LilTunechi25]

Originally Posted by -={Nexus}=- Flashed on original dump, on a sur-001 ps3 slim motherboard and received a black screen. It runs but there is no sound or video. Tried video reset and it still brought up nothing on screen as well as tried a new hdmi cable and av cords for video. Even tried to downgrade with it in this state both with downgrade.bin one-key downgrade and flow rebuilder patch and it would simply ylod once process was finished. The log file after downgrade read that it went through OK. Flashed back on original dump again and back to the black screen the same as before. Any suggestions would be greatly appreciated and thank you for your time. ************* [ - Post Merged - ] ************* After reading someone elses thread, i followed playerpk420's suggestion and made a backup of the ps3 after flashing on the original dump file. I compared my original dump with what was flashed on and they both are identical. SO this would rule out any bad connections during the flash procedure. Why am I getting a black screen? So frustrated ...ARGh!

get a new clip or solder then reflash

[-={Nexus}=-]

I am actually currently wired in with solder and 26AWG wire

[3absiso]

Originally Posted by -={Nexus}=- I am actually currently wired in with solder and 26AWG wire

So, you using the Clip or the linker?

1000 Post

[-={Nexus}=-]

haha congratz!

Using the e3 linker and e3 flasher with hard drive caddy on the side

[playerkp420]

Are you sure you flashed the correct bkpps3.bin? And not the bkpps3.swap.bin?

Check your dump in HxD. In offset 000200 it should say FI.I, not IFI

[-={Nexus}=-]

Yup that's the one i'm using FI.I.

Not using the reverse byte one.

[3absiso]

Originally Posted by -={Nexus}=- Yup that's the one i'm using FI.I. Not using the reverse byte one.

And the PS3 was working before you attempted the Downgrade?
when you pulled the mobo from the Metal Cage, you did it right and did not use force?

are you sure the dump is for the Same PS3? just asking

[playerkp420]

Originally Posted by -={Nexus}=- Yup that's the one i'm using FI.I. Not using the reverse byte one.

What was the reason for flashing your original dump? Were you trying to Half dual boot?

When you turn on your PS3, is there any HDD activity?
Do the USB ports have power?

[sinsizer]

Maybe you can upload your dump for public, so more people can have a look at it.
If you are worried about your idps simply delete the 16byte at 0x2F070 and 0x303D0.